Adhesive for precision fixing
feature
- Adhesive fixation on the order of submicrons is possible because there is very little change in fixing position due to curing or temperature changes.
*Low cure shrinkage (less than 2%)
*Low coefficient of thermal expansion (40 ppm/℃ or less)
- AT9290F becomes transparent after curing
- High reliability that withstands heat cycle tests (-40 to 85°C)
- High heat resistance (260°C) that withstands solder reflow processing
[Usage example] Fixing microball lenses
characteristic values
| model number [main component] |
viscosity (mPa・S) |
Curing conditions [Irradiation intensity, time] |
cure shrinkage (%) |
Glass-transition temperature Tg (°C) |
coefficient of thermal expansion (ppm/°C) |
Adhesion strength (kgf/cm2) |
Features |
|---|---|---|---|---|---|---|---|
| AT4291A [Epoxy] (*1) |
25,000 | 100mW/ cm2 10 minutes |
2 | 206 | 23 | >116 | low viscosity |
| AT9290F [Epoxy] (*1) |
45,000 | 100mW/ cm2 10 minutes |
1 | 140 | 31 | >200 | Transparent after curing (Large curing depth) |
| AT3862P [Epoxy] (*1) |
180,000 | 100mW/ cm2 10 minutes |
0.5 | 195 | 20 | >210 | Small cure shrinkage high viscosity |
| AT3916P [Epoxy] (*1) |
36,000 | 100mW/ cm2 10 minutes |
0.9 | 233 | 18 | >220 | low viscosity |
*1...This product contains a "non-medicinal hazardous substance" (please refer to the SDS (MSDS) for handling instructions).
The characteristic values in the table are sample measurement values, not guaranteed values.
About purchase
For purchases or inquiries, please contact us via the inquiry form.
Outside of Japan, sales may be prohibited in some countries due to laws and regulations concerning chemical substances.
For information on overseas distributors, please check here.
Distributors List